AGM-02 Area Gamma Monitors are suitable for measuring ambient gamma dose rates equivalent from natural background up to 100 mSv/hr. It can be used as an area gamma monitor or gate monitor with local or remote indication in host systems.

​

#VF

#Dose Rate Meters

The MDG-12S and MDG-13S Directional Dose Rate Meters are intended for directional dose rate measurements. The meters are suitable for process measurements in areas with more sources, where only one source and/or one technological section should be monitored and the effect of other sources should be eliminated.

​

#VF

#Dose Rate Meters

MDG-0X Dose rate meters are suitable for measuring gamma dose rate or dose equivalent from very low levels corresponding to natural background up to units of Gy/h or Sv/h. They can be used as area gamma or gate monitors with local or remote indication in host systems.

​

#VF

#Dose Rate Meters

The NGM-2000 is a state-ofthe-art device designed for quasi-continuous nuclide specific activity monitoring of noble gases which are discharged from ventilation stacks and pipelines. Thanks to its unique design the NGM-2000 offers very low detection limits.

​

#VF

#Particulate Iodine and Noble Gas Monitors

The vacuum pump VP-110 is intended to ensure continuous air intake to a volume activity monitor. The unit serves primarily CPM-300 and CPM-310 Continuous Particulate Monitors.

​

#VF

#Particulate Iodine and Noble Gas Monitors

SDG-5X series detectors are intended for gamma-ray measurements using NaI(Tl) scintillation crystals. For example, the detectors can be used in high sensitive dose rate meters or process monitors.

​

#VF

#Dose Rate Meters

The LAM-501 Liquid Activity Monitor is intended for the on-line measurement of gamma activity of liquids flowing through pipelines. The monitor can work as an autonomous monitor as well as a part of a large monitoring system.

#VF

#Liquid Monitors

The MAB-23 monitor is designed for operative monitoring of the area with the possible occurrence of beta particulates. It measures the activity of the particulates on the filter and recalculates it to air volume activity. The monitor allows the rapid examination of the radiation situation, typically before the start of temporary works.

​

#VF

#Particulate Iodine and Noble Gas Monitors

The CPM-300 monitor is designed to continuously measure the alpha and beta particulates concentration in the air. It displays and archives the measured values and activates the alarm if the pre-set threshold level values are exceeded.

​

#VF

#Particulate Iodine and Noble Gas Monitors

The NGD-03 and NGD-04 Noble Gas Detectors are intended for continuous measurements of noble gas beta volume activity in the air mass of ventilation stack discharges, in pipelines and technological systems as well as in the environment.

​

#VF

#Particulate Iodine and Noble Gas Monitors

The NGM-2000 is a state-ofthe-art device designed for quasi-continuous nuclide specific activity monitoring of noble gases which are discharged from ventilation stacks and pipelines. Thanks to its unique design the NGM-2000 offers very low detection limits.

​

#VF

#Particulate Iodine and Noble Gas Monitors

The MDN-01 and SND-01 meters are designed for the measurement of ambient dose equivalent rate H*(10) in neutron fields in environments, such as nuclear facilities, hospitals, workplaces with particle accelerators, etc.

​

#VF

#Neutron Monitors

The SND-01 Smart Neutron Detector, when connected to Radcount-2S, can serve as a portable monitor of neutron dose rate equivalent H*(10).

​

#VF

#Neutron Monitors

“Waste-Scan” WAM-200 monitors are used for spectrometric characterization of radioactive waste. It can be used in nuclear power plants, waste repositories, science facilities, reprocessing plants etc. for typically LLW/ILW measurements or free release.

​

#VF

#Waste Monitors

Document contamination monitor DCM-300 is intended for detection of beta/gamma contamination of documents. It can be used especially in controlled areas at nuclear power plants.

​

#VF

#Contamination Monitors

The SFP-100 smart frisking probe is a hand-held device suitable for alpha, beta and gamma surface contamination detection. When connected to a suitable display unit, it can be used for contamination monitoring of personnel or objects.

​

#VF

#Contamination Monitors

The MCM-300 contamination monitor is intended for monitoring and contamination indication of tools and other objects and materials contaminated by radioactive substances. It is used in nuclear power facilities and in medical industry.

​

#VF

#Contamination Monitors

The FCM-02 enables workers in radiation controlled areas to quickly measure the alpha, beta and gamma contamination on their clothes. Tools and other items being brought out of controlled areas can also be measured.

​

#VF

#Contamination Monitors

Laundry Contamination Monitors LCM-300 series are mobile devices that serve for checking contamination of laundry by alpha, beta and gamma emitting radionuclides. They can also be used for checking contamination of other subjects of suitable size.

​

#VF

#Contamination Monitors

The HF series hand-foot contamination monitors are intended for measurement of surface contamination by alpha, beta and gamma emitting radionuclides on hands, feet and clothing. Typical usage is at nuclear power plants, radio-chemical plants, research institutes, hospitals, etc.

​

#VF

#Contamination Monitors

ExitScan-2 is a new type of a whole-body exit monitor designed for checking contamination of personnel leaving controlled areas of nuclear facilities. By utilizing smart scintillation detectors it can check the contamination of personnel by alpha, beta and gamma emitting radionuclides, as required.

​

#VF

#Contamination Monitors

The HM series hand contamination monitors are intended for measurement of surface contamination by alpha, beta and gamma emitting radionuclides on hands, feet and clothing. Typical usage is at nuclear power plants, radio-chemical plants, research institutes, hospitals, etc.

​

#VF

#Contamination Monitors

SIM-27G and SIM-101G Small Items Monitors are instruments designed for checking and indicating the gamma contamination of small items, for example, protective helmets, various kinds of tools and other equipment. They are primarily used at the exits from radiation controlled areas in nuclear power plants.

​

#VF

#Contamination Monitors

“Waste-Scan” WAM-300 monitors are used for spectrometric characterization of radioactive waste. It can be used in nuclear power plants, waste repositories, science facilities, reprocessing plants etc. for typically LLW/ILW measurements or free release.

​

#VF

#Waste Monitors

FRM-02 monitors are intended for measuring and analysing the integral activity of gamma-emitting radionuclides in waste. Based on the measurements, it is possible to decide whether the material is to be free released into the environment or not.

​

#VF

#Waste Monitors

FRM-24 represents a complex monitoring facility which is used for activity monitoring and radionuclide analysis in waste material before its release into the environment. Based on results it is possible to make a decision about the next waste management.

​

#VF

#Waste Monitors

“Waste-Scan” WAM-202 monitors are used for spectrometric characterization of radioactive waste. It can be used in nuclear power plants, waste repositories, science facilities, reprocessing plants etc. for typically LLW/ILW measurements or free release.

​

#VF

#Waste Monitors

FRM-06 represents a complex monitoring facility which is used for the activity measurement and radionuclide analysis in waste material stored in standard roll-off container. Based on the results it is possible to make a decision about next waste management.

​

#VF

#Waste Monitors

“Waste-Scan” WAM-202 monitors are used for spectrometric characterization of radioactive waste. It can be used in nuclear power plants, waste repositories, science facilities, reprocessing plants etc. for typically LLW/ILW measurements or free release.

​

#VF

#Waste Monitors

Equipment of the ”V3H14C” family are designed for H-3 and C-14 sampling from the air. Several versions are produced, ranging from a compact model for the sampling of tritium in the form of water, to a version enabling differential sampling of both the oxidised and unoxidised form of tritium, and the organic and inorganic form of C-14.

​

#VF

#Air Samplers

The ASU-50 Alarm Slave Unit is intended for strong optical and acoustic alarm indication of pre-set threshold limits exceeding. It connects smart detector, monitor, local display unit or host monitoring system.

​

#VF

#Processing Display and Alarm Units

The LZJ-10 unit is modular and highly versatile device enabling a variety of different types of radiation detectors to be connected. LZJ-10 provides acquisition, processing, displaying, local archiving and transmission to the host system of signals coming from up to eleven radiation detectors.

​

#VF

#Processing Display and Alarm Units

The LZJ-22 local display unit is a state-of-art device intended for use with radiation monitoring systems. It is intended for the signals processing from the connected detection units, local display, local archive and signalling of alarms.

​

#VF

#Processing Display and Alarm Units

The DPD dispensers of personal dosimeters are used for the automatic, fast and controlled issuing of personal dosimeters for workers who enter into controlled areas, especially in nuclear power plants and other nuclear facilities.

​

#VF

#Dosimetry

The VOPV-10 high-volume air sampler is intended for air sampling of very high volumes allowing for follow-up contamination measurement. It is typically utilised for the sampling and evaluation of radioactive aerosols, particulates, etc. in the contaminated air.

​

#VF

#Air Samplers

The VOPV-7 high-volume sampler is intended for air sampling of very high volumes allowing for follow-up contamination measurement. It is often utilised for the sampling and evaluation of radioactive aerosols, dust, etc. in the contaminated air.

​

#VF

#Air Samplers

The BOA-80 sampler is intended for aerosol sampling from the air for pollution measurements, typically radioactive contamination. The flow rate of the air being sampled can be constant or proportional to the flow rate in the ventilation line.

​

#VF

#Air Samplers

OTK-01 product series represents the tritium sampler that uses the condensation method, and that does not require an absorption medium. It is used for the gaseous discharges monitoring in nuclear facilities.

​

#VF

#Air Samplers

The PAM-170 series meters are portable hand-held instruments intended for the measurement of surface contamination by alpha, beta and gamma emitting radionuclides. A compact and ergonomically designed user friendly meter.

​

#VF

#Laboratory Equipment and Portable Measuring Devices

The NGS-2000 Noble Gas Sampler is intended for collecting air samples from ventilation stacks of nuclear facilities. Subsequently, the noble gases specific activity of collected sample is evaluated in the laboratory by using spectrometric HPGe detector.

​

#VF

#Air Samplers

The VOPV-12 High-volume air sampler is intended for air sampling of very high volumes allowing for a follow-up air contamination measurement. It is utilised for the sampling and evaluation of radioactive aerosols, particulates, etc. in the contaminated air.

​

#VF

#Air Samplers

The PAM-100 series meters are portable hand-held instruments intended for the measurement of surface contamination by alpha, beta and gamma emitting radionuclides. A compact and ergonomically designed user friendly meter.

​

#VF

#Laboratory Equipment and Portable Measuring Devices

Gaseous Effluent Sampler is intended for accident and post-accident ventilation stack air sampling for further evaluation of radioactive aerosols and iodine discharges. Two shielded chambers ensure continuous sampling during high activity event.

​

#VF

#Air Samplers

​

VF RMS radiation monitoring system is a modular and standardized system for the radiological monitoring. Variety of radiation monitors, display and alarm units can be connected to the RMS system.

​

#VF

#Radiatiation Monitoring Systems

The PAM-525 series meters are portable hand-held instruments intended for the measurement of surface contamination by alpha, beta and gamma emitting radionuclides. Thanks to detector size it enables large areas to be quickly examined.

​

#VF

#Laboratory Equipment and Portable Measuring Devices

Gamma Calibration Laboratory facilitates the whole calibration process with its state-of-the-art concept, technology, and many optional features. Various gamma radiation sources can be used to generate a range of dose rates, up to 10 Gy/h.

​

#VF

#Equipment for Metrological Laboratories of Ionising Radiation

The DJ-500 desorption unit is used for tritiated water desorption which is trapped in Silica gel or another sorbent. This allows follow-up analysis of the liquid sample in the laboratory using liquid scintillation counting method.

​

#VF

#Laboratory Equipment and Portable Measuring Devices

Radcount-2S display unit can be used with variety of VF’s smart detectors. When connected with SFP smart frisking probe it can serve as a portable handheld contamination monitor of alpha, beta and gamma emitting radionuclides.

​

#VF

#Laboratory Equipment and Portable Measuring Devices